Zhone Technologies IMACS-200 - Manual (Page 174)

7-14 E&M Ports
Model No. Running Head
TYPE
The Type informational field shows the current status of the signal field selected on the main
E&M port screen for this port. Valid settings for E&M and wink modes is loop (loop start).
STATUS
The Status field shows the current status of the port. Table 7-5 lists and describes all of the
possible conditions reported by this field.
Table 7-5. Status Information Field Settings
Setting Meaning
stdby The E&M port is in standby.
W stb WAN port to which the E&M port is assigned is in standby.
W tst WAN port to which the E&M port is assigned is under test.
W OOS WAN port to which the E&M port is assigned is out of service.
noWAN There is no WAN port configured in the slot to which the E&M port is
assigned.
call Call set-up is in progress.
busy Call is in progress.
idle No call is in progress (port is available for a call).
TC The port is in Trunk Conditioning because a CGA alarm occurred on the
associated WAN port.
test A test is in progress on the port (i.e., you are actively controlling the circuit
by setting values for Tx ABCD or Rx ABCD).
maint The port is in a maintenance condition.