Zhone Technologies IMACS-200 - Manual (Page 265)

Error Messages B-1
Appendix B
Error Messages
B.1 Introduction
This appendix lists the IMACS-200 error messages. One of these messages may appear at the
bottom of the screen when you enter a command, indicating that the system did not perform
the requested action. This condition may have been caused by an operator error, absence of a
port in the system, or other condition. If an error message appears, take the appropriate
corrective action. For convenience, the system error messages are listed alphabetically.
A name must be assigned to Circuit ID field.
You must enter a name for the circuit before attempting this operation. Go to the Circuit ID
field, type the desired name, and save it.
All blank prt report.
You chose the empty option setting for all four elements of the Print Alarm on the Interface
port. This combination of settings is invalid and cannot be saved. Choose the proper option
settings for these elements.
ASYNC/5 databits must have 2 stop or parity.
You have assigned an SRU port to an asynchronous circuit with 5 data bits, one stop bit, and
no parity. This is an invalid combination of option settings. Either choose two (2) stop bits, or
enable parity on that port.
Both WAN’s cannot be in test mode.
You cannot use the test option on both sides of a cross-connect simultaneously.
Cannot be STDBY while BERT test is running.
You cannot change a port from the actv (active) state to the stdby (standby) state while the Bit
Error Rate Tester (BERT) is running. You must end the BERT test first.