Zhone Technologies IMACS-200 - Manual (Page 266)

B-2 Error Messages
Model No. Running Head
Cannot define any more XCON circuits.
The maximum number of cross-connect circuits is 99.
Can NOT delete circuit while test is active.
You must end the test in progress before deleting the circuit.
Cannot do it in Viewer mode.
You are logged in under the Viewer password, but that level of access does not allow you to
perform the desired operation. Log out of the system, log back in under the Operator or
Manager password, and repeat the command. Or, perform an operation that is permitted by the
Viewer access level.
Cannot have REMOTE and LOCAL loopbacks.
You cannot place the port in both a local loopback and a remote loopback simultaneously.
Cannot insert errors without BERT running.
You must start BERT testing before inserting bit errors.
Cannot switch non-compatible WANs.
The current WAN port arrangement does not support redundant WAN switching.
Cannot switch to a non-operational WAN.
You cannot switch to the selected WAN port because it is out of service.
Cannot use the same TS on different WAN.
You cannot assign an SRU port to the same time slot on different WAN ports.
Card is not available.
You cannot test the port because it is faulty.