Zhone Technologies IMACS-200 - Manual (Page 106)

4-22 General Features
Model No. Running Head Remote Administration IMACS-200 General Features
4. Enter in the HOST NETMASK: [IP mask]
5. Select the HOST TYPE as either host or gateway. As a host system, the IMACS-200
terminates the IP when packets are destined for its address. As a gateway, the IMACS-200
has the ability to perform packet-forwarding to another destination.When choosing the
gateway option, the user can only select WAN as the Default IP type. Figure 4-12
illustrates the ability of the IMACS-200 to perform this daisy-chaining function in the IP
cloud.
Figure 4-12.IP Daisy-chaining on the IMACS-200
6. Select the DEFAULT IP TYPE as either none, local ethernet or wan
a. If wan is chosen, then the IP SLOT and IP TS will be accessible to the user. If this is
the case, datafill these fields with the WAN and timeslot where the Ethernet port will
be carried. Use of these fields will provide timeslots to the IMACS-200. Otherwise,
these fields will be n/a by default. Performing this action will set up port SCC3 as seen
in Figure 4-13, which enables the upstream management channel.
Figure 4-13.Displaying the SCC ports