Zhone Technologies IMACS-200 - Manual (Page 234)

13-4 OWAN Ports
Model No. Running Head
Figure 13-2.IMACS-200 Main screen
The main login screen shows port statuses for the OWAN ports. Two sections are provided,
separated by a space. The first two status indicators as shown in figure are the Optical transport
medium status indicators. In the illustration, the first port is active, indicated by the ‘a’ on the
screen. The second port shows an ‘r’ for this optical ports redundant status. The individual E1
or T1 ports carried by the optical port are shown grouped together after the space, and in the
above case all ports are in standby, ‘s’ state.
13.3.1 OWAN Functional Notes
Currently the OWAN does not support the SA4 bit in E1 mode. This functionality is planned
for a future release. In addition, T1 does not currently support loopback generate and detect
events, and will also be available in a later release. E1 loopback generation and detect are not
defined, and are not supported. SNMP capability on the OWAN port will be delivered in a later
release as well, and will be fully functional with Online software 1.3.1 and above. Currently
the IMACS-200 is supported in Online version 1.3.0.
13.3.2 OWAN Optical Port Main Screen
You must configure the OWAN port ports for operation. Configuration can be performed from
the OWAN port Main Screen, which is shown in Figure 13-3. To access that screen, highlight
the desired port in the System Main Screen and press <Enter>.