Wan and owan interface un-provisioned setting -4 – Zhone Technologies IMACS-200 User Manual

Page 46

Advertising
background image

3-4

System Operation

Model No.

Running Head

System Power-up

System Configuration and Operation

5. Once system access has been obtained, the IMACS 200 will prompt the user to assign
WAN and OWAN (if provisoined) port defaults. All four of the WAN or OWAN ports
must be set to the same interface type (T1 or E1). This main screen is shown in Figure 3-3.
Currently, the OWAN and WAN must be set to the same interface type, either E1 or T1.

Caution should be exercised when choosing the interface type to the WAN and OWAN.
All four ports available to the interface must be set to the same type, and changing the type
will require a reboot of the system software, dropping all services. Prior to the change, all
existing services and WAN / OWAN ports must be in the standby state.

Figure 3-3.WAN and OWAN Interface Un-provisioned Setting

Once the WAN and OWAN Types have been set as either T1 or E1, the user must save the
setting. This will prompt a reboot of the IMACS 200, and once completed then the typical
login screen will appear, as seen in step 6.

6. The System Main Screen appears. Figure 3-4 shows this screen.

Advertising