Zhone Technologies IMACS-200 - Manual (Page 166)

7-6 E&M Ports
Model No. Running Head
7.3 E&M port User Screens and Settings
7.3.1 E&M port Main Screen
You must configure the E&M port for operation after installing it in the system chassis. This
is done from the E&M Main port Screen, which is shown in Figure 7-5. To go to that screen,
highlight the desired port on the System Main Screen, then press <Enter>. The E&M port
Main Screen shows four columns of settings, one for each of the E&M ports.
Figure 7-5.Typical E&M port Main Screen
The bottom highlighted line of this screen shows various actions that you can perform from
this screen. You perform the desired action by pressing the associated uppercase letter key.
Table 7-1 on page 7 summarizes these actions. For example, after you configure the E&M port
ports, press “s” to save your settings.