3 setting the unit on scaled channels, 3 setting the unit on scaled channels -12, 3 settng the unt on scaled channels – Yokogawa µR10000 User Manual
Page 112
IM 04P01B01-01E
5-12
5.3 Settng the Unt on Scaled Channels
Units are set on channels whose input range is set to Scaling, 1-5V, or SQRT.
Procedure
1.
Hold down the
MENU
key for 3 seconds to enter Setting mode.
2.
Press the
key or
SHIFT +
key to select
Unt and then press the key.
3.
Set each item and press the key.
Use the
key or
SHIFT +
key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the
ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
4.
When the
Settng complete screen appears, do either of the following:
Press the key to set other channels.
If you are done, press the
ESC key.
5.
Hold down the
MENU
key for 3 seconds to return to Operation mode.
Set the unit.
Set the channel range.
The new setting takes effect.
First channel
Last channel
ESC/?
Set=Unit
CH=01-01
Unit=
01-01 Channel
Setting complete
Explanaton
Characters That Can Be Used for Unts
A unit is set using up to six characters.
The available characters are as follows:
Alphabet, numbers, symbols (%, #, °, @, +, –, *, /, (, ), µ, Ω,
2
,
3
, .), and space