Yokogawa µR10000 - Manual (Page 89)

IM 04P01B01-01E
4-2
4.2 Key Operatons
This section describes basic operations on the panel keys to change various settings.
Functions are set in Setting mode or Basic Setting mode.
Enterng Settng Mode
Hold down the MENU key for 3 seconds.
The Setting mode display appears. The top and bottom lines are the setup item and
comment, respectively.
The section that is blinking in the setup item that you change. In this manual, the section
that you change appears shaded.
The item to be controlled blinks. Setup item
Comment
Set=Range
Input range and
The panel keys are set to the functions marked above the keys.
RCD MENU FEED CH UP FUNC MENU DISP 1
CHARACTER ESC/? SHIFT
Extng from Settng Mode (Returnng to Operaton Mode)
Hold down the
MENU
key for 3 seconds.
The screen returns to operation mode.
Enterng Basc Settng Mode
Basic Setting mode is entered from Setting mode.
Hold down the
MENU key for 3 seconds to enter Setting mode. Next, hold down both the
( DISP ) key and the ( FUNC ) key for 3 seconds.
The Basic Setting mode display appears. The top and bottom lines are the setup item
and comment, respectively.
The section that is blinking in the setup item that you change. In this manual, the section
that you change appears shaded.
The item to be controlled blinks. Setup item
Comment
Basic=Alarm
Auxiliary alarm
Extng from Basc Settng Mode (Returnng to Operaton Mode)
This operation is used to return to Operation mode after changing the settings in Basic
Setting mode.
Press the
ESC key several times to return to the Basc= screen.
Press the key or SHIFT + key to select End and then press the key. The
setup save screen appears.
Basic=End
Save Settings
Press the key to select Store and then press the key. The setting is applied,
and the screen returns to Operation mode. If you select Abort and press the key, the
setting is discarded, and the screen returns to Operation mode.
End=Store
Save settings and