Yokogawa µR10000 - Manual (Page 3)

IM 04P01B01-01E

Recorder’s Verson and Functons Descrbed n Ths
Manual
The contents of this manual corresponds to the recorder with version 1.31.
µR10000 Versons and Functons
Verson Suffx Code Added or Modfed Functons Reference
1.02 or earlier – – –
1.11 – (Added) The printout/display format of the date can be changed. Section 7.19
– (Added) Key operation to move the printer carriage near the
center position so that the ribbon cassette can be
replaced with the recorder turned ON (dot model)
Section 3.4
– (Changed) Selectable range of alarm values during linear scaling
(including 1-5V and SQRT) to –5% to 105% of the
scale span.
Section 5.2
– (Changed) The procedure to set the start/end date and time of
Daylight Saving Time (DST) has been changed.
Section 6.16
/C3 (Added) Modbus/RTU slave protocol, two-wire system. Communication manual
/C7 (Changed) Users with the same user name cannot be registered. Communication manual
1.21 -2 (Added) Language support (German and French). Section 1.9
/CC1 (Added) Calibration Correction. Section 1.2
/H5x (Added) Portable type. Sections 2.5 and 12.7
/P1 (Added) 24 VDC/AC power supply operation. Section 2.5
1.31 – (Added) Customized menu. Section 1.9
– (Added) Modbus register (40301 to 40348). Communication manual
/BT1 (Added) Header printout. Section 1.4
• Checking the Version Number
You can check the version number on the System display.
The System display cannot be shown at the factory default condition.
First, register the System display to the display screen.
• Procedure of registering the System display to the display screen: See section 8.2.
• Procedure of displaying the System display: The screen switches each time the
DISP key is pressed. Press
the DISP key repeatedly until System display is shown. The displayed contents on the System display
switches every 3 seconds. Check the number shown by the “Version:” item.
Software (Sold Separately)
The table below shows the relationship between the RXA10 Configuration Software revisions and the µR10000
recorder versions.
Recorder verson
1.02 or earlier 1.11 1.21 1.31
RXA10 Confguraton
Software revson
R1.01 Yes Limited
R2.01 Yes Yes Yes Limited
R3.01 Yes Yes Yes Yes
Yes: Compatible
Limited: The new functions of the recorder cannot be configured from the RXA10.
Note
Set the recorder version in the RXA10 Configuration Software to display the setup items that
match the recorder’s functions.