Yokogawa µR10000 - Manual (Page 80)

IM 04P01B01-01E
3-12
3.6 Swtchng the Dsplay Screen
This section describes the procedure for switching the display screen.
To change the displayed content, see chapter 8.
Procedure
Swtchng the Dsplay Screen
The display screen switches each time the
DISP
key is pressed.
Screen 01 through 15 are switched in order. Screens that are set to “Skip” are skipped.
Channel Auto Swtchng
On screens that show the measured values and computed values, the displayed channel
is automatically switched in ascending order. The switching interval can be set to 1 s, 2 s,
3 s, 4 s, or 5 s.
Measurement channels set to Skip and computation channels set to OFF are not
displayed.
Swtchng the Dsplayed Channel Usng Keys
If Manual switching is specified, the channel switches each time the
CH UP
key is pressed
in ascending order. All channels are displayed in order.
Note
The operation is different between auto channel switching and manual switching using keys on
the 2-channel digital display.
03
04
05
06
01
02
02
03
03
04
01
02
During auto switching
When switching using keys