Yokogawa µR10000 - Manual (Page 120)

IM 04P01B01-01E
6-6
6.6 Turnng Trend Recordng (Dot Model) and
Perodc Prntout ON/OFF for Each Channel
This section explains the details of setting the trend recording and periodic printout for
each measurement channel.
The following settings can be entered for each channel.
• Turn trend recording ON/OFF (dot model only).
• Turn the printing of measured values ON/OFF during periodic printout.
Procedure
1. Hold down the
MENU
key for 3 seconds to enter Setting mode.
2. Press the key or SHIFT + key to select Aux and then press the key.
3. Press the key or SHIFT + key to select Prnt out and then press the
key.
4. Set each item and press the key.
Use the key or SHIFT + key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the
ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
5. When the Settng complete screen appears, do either of the following:
Press the key to set other channels.
If you are done, press the
ESC key.
6. Hold down the MENU key for 3 seconds to return to Operation mode.
Set the channel range.
Turn trend recording On/Off.
Select whether to print the measured
values during periodic printout (On/Off).
The new setting takes effect.
ESC/?
First channel Last channel
Set=Aux
Aux=Print out
CH=01-01
Trend=On
Periodic=On
01-01 Channel
Setting complete
(Dot model)
Explanaton
Trend Recordng (Dot Model)
On: Turns On the trend recording of the specified channel.
Perodc Prntout
On: Prints the measured values (instantaneous values or report data) of the specified
channel during periodic printout.
Off: Does not print the channels and measured values during periodic printout.