Yokogawa µR10000 - Manual (Page 118)

IM 04P01B01-01E
6-4
6.4 Settng Recordng Zones for Each Channel
(Zone Recordng)
This section explains the details of setting the recording zone for each measurement
channel.
Procedure
1. Hold down the
MENU
key for 3 seconds to enter Setting mode.
2. Press the key or SHIFT + key to select Aux and then press the key.
3. Press the key or SHIFT + key to select Zone and then press the key.
4. Set each item and press the key.
Use the key or SHIFT + key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the
ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
5. When the Settng complete screen appears, do either of the following:
Press the key to set other channels.
If you are done, press the
ESC key.
6. Hold down the MENU key for 3 seconds to return to Operation mode.
Set the channel range.
Set the leftmost value of the
recording zone.
Set the rightmost value of the
recording zone.
The new setting takes effect.
First channel Last channel
ESC/?
Set=Aux
Aux=Zone
CH=01-01
Left= 0
Right=100
01-01 Channel
Setting complete
Explanaton
Zone
The recording zone can be set in the following range.
Leftmost position: 0 mm to 95 mm
Rightmost position: 5 mm to 100 mm
Set a larger value for the rightmost position than the leftmost position.
Set at least 5 mm for the zone width.
Note
If the zone is set to a value less than 40 mm, scale printout of periodic printout cannot be
executed.