Yokogawa µR10000 - Manual (Page 177)

IM 04P01B01-01E
7-40
7.24 Enablng Start Prntout, End prntout, and
Message Format (/BT1 Opton)
This section explains the details of enabling/disabling the Start printout, End printout, and
Message format.
Basic Setting mode cannot be entered when recording is in progress or when
computation is in progress on models with the computation function (/M1 option).
Procedure
Changng the Settngs
1. Hold down the MENU key for 3 seconds to enter Setting mode.
2. Hold down the and keys simultaneously for 3 seconds to enter Basic
Setting mode.
3. Press the key or SHIFT + key to select Batch and then press the
key.
4. Set each item and press the key.
Use the key or SHIFT + key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the
ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
5. When the Settng complete screen appears, do either of the following:
To correct the setting the key.
If you are done, press the
ESC key.
Basic=Batch
Dual comment=Use
Basic batch
Setting complete
Enable/disable the Start printout and
End printout function.
Select 4 or 6 digits for the number of
digits in the lot number, or disable.
Select to enable or disable Start
printout 2 and End printout 2.
The new setting takes effect.
MSG format=Use Enable/disable the message format
function.
ESC/?
Batch=Use
(Only when batch is set to Use)
(Only when batch is set to Use)
Lot No.=4
Applyng the Changes and Returnng to Operaton Mode
Press the key or SHIFT + key to select End and then press the key. Press
the key to select Store and then press the key. The changes are applied, and
the screen returns to Operation mode. If you select Abort and press the key, the
changes are discarded, and the screen returns to Operation mode. Press the ESC key to
return to the Basc= screen.