Yokogawa µR10000 - Manual (Page 149)

IM 04P01B01-01E
7-12
7.8 Settng the Perodc Prntout Interval and the
Type of Data to Be Prnted
This section explains the details of setting the periodic printout interval and the type of
data to be printed.
Basic Setting mode cannot be entered when recording is in progress or when
computation is in progress on models with the computation function (/M1 option).
Procedure
Perodc Prntout Interval and Type of Data to Be Prnted
Changng the Settngs
1. Hold down the
MENU
key for 3 seconds to enter Setting mode.
2. Hold down the and keys simultaneously for 3 seconds to enter Basic
Setting mode.
3. Press the key or SHIFT + key to select Prnt1 and then press the
key.
4. Set each item and press the key.
Use the key or SHIFT + key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the
ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
5. When the Settng complete screen appears, do either of the following:
To correct the setting, press the key.
If you are done, press the
ESC key.
(When Period is set to Manual)
Set the reference time.
Select the periodic printout interval mode.
Select the periodic printout interval.
Set the type of data to be printed to
instantaneous value or report.
Select Off to disable periodic printout.
The new setting takes effect.
ESC/?
Printout1
Setting complete
Basic=Print1
Periodic=Auto
Ref.Time=00:00
Interval=1h
Mode=Inst
Applyng the Changes and Returnng to Operaton Mode
Press the key or SHIFT + key to select End and then press the key. Press
the key to select Store and then press the key. The changes are applied, and
the screen returns to Operation mode. If you select Abort and press the key, the
changes are discarded, and the screen returns to Operation mode. Press the ESC key to
return to the Basc= screen.