Yokogawa µR10000 - Manual (Page 88)

4-1
IM 04P01B01-01E
Common Operations for Setting Functions and Setup Menu
Chapter 4 Common Operations for Setting Functions and Setup Menu
1
2
3
4
5
6
7
8
9
10
11
12
App
Index
4.1 Run Modes
The recorder has three run modes.
Operation Mode
This mode is used for normal recording operation. The recorder enters this mode
when the power is turned ON. The operations that can be carried out in this mode are
described in chapter 3. The details on the data display setup screen are explained in
chapter 8.
Setting Mode
This mode is used to set the input range, alarms, chart speed, and other parameters.
These settings can be changed while recording is in progress. However, the input
range of measurement channels and the computing equation, unit, constant, and TLOG
setting of computation channels cannot be changed while computation (/M1 option) is in
progress. The operations that can be carried out in this mode are described in chapter 5
and 6.
Basic Setting Mode
This mode is used to set the basic specifications of the recorder such as the
thermocouple burnout detection function and the alarm output relay operation. This mode
cannot be entered while the recorder is recording or while computation is in progress
on the computation function (/M1 option). Measurement, recording, and alarm detection
cannot be carried out in this mode. The operations that can be carried out in this mode
are described in chapter 7.
Operation mode
Power ON
Setting mode
Data display setup screen
Basic Setting mode
MENU 1
Display “End=Store” and press
MENU
Hold down
for 3 s
Hold down
Hold down
+ for 3 s
for 3 s
Data display screen