Yokogawa µR10000 - Manual (Page 129)

6-15
IM 04P01B01-01E
Setup
Operat
ons
for
Conven
ent
Funct
ons
(Sett
ng
Mode)
1
2
3
4
5
6
7
8
9
10
11
12
App
Index
6.14 Settng Up Start Prntout and End prntout
(/BT1 Opton)
Enter settings for Start printout/Start printout 2 when starting recording, and for End
printout/End printout 2 when stopping recording.
You cannot enter Basic Setting mode during the time between start printout to end
printout.
Procedure
1. Hold down the
MENU
key for 3 seconds to enter Setting mode.
2. Press the key or SHIFT + key to select Batch and then press the
key.
3. Set each item and press the key.
Use the key or SHIFT + key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the
ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
4. When the Settng complete screen appears, do either of the following:
To correct the setting the key.
If you are done, press the
ESC key.
5. Hold down the MENU key for 3 seconds to return to Operation mode.
Settng the Batch Number
Set=Batch
No.=
Batch No.
Setting complete
Set the batch number.
Select Batch No.
The new setting takes effect.
Batch=Batch No.
ESC/?
Settng the Lot Number
Set=Batch
Lot No.= 0
Batch lot No.
Setting complete
Set the lot number.
The new setting takes effect.
Batch=Lot No.
ESC/?
(When the Lot No. in Basic Setting
mode is 4 or 6)
Select Lot No.