Brocade BigIron RX Series Configuration Guide - Manual (Page 1055)

BigIron RX Series Configuration Guide 977
53-1002484-04
Displaying IPv4 IS-IS information
29
TABLE 152 IS-IS detailed LSP database information
This field... Displays...
LSPID See the description of the summary display.
LSP Seq Num See the description of the summary display.
LSP Checksum See the description of the summary display.
LSP Holdtime See the description of the summary display.
ATT/P/OL See the description of the summary display.
Area Address The address of the area.
NLPID The Network Layer Protocol Identifier (NLPID), which specifies the
protocol the IS that sent the LSP is using. Usually, this value is “CC(IP)”.
BigIron RX# show isis database detail
IS-IS Level-1 Link State Database
LSPID LSP Seq Num LSP Checksum LSP Holdtime ATT/P/OL
RX.00-00* 0x0000000b 0x23fb 971 1/0/0
Area Address: 49
NLPID: CC(IP)
Hostname: RX
Metric: 10 IP-Internal 4.1.1.0/24 Up-bit: 0
Metric: 10 IS RX.01
IS-IS Level-2 Link State Database
LSPID LSP Seq Num LSP Checksum LSP Holdtime ATT/P/OL
RX.00-00* 0x0000000d 0x7d97 903 1/0/0
Area Address: 49
NLPID: CC(IP)
Hostname: RX
IP address: 4.1.1.1
Metric: 10 IP-Internal 4.1.1.0/24 Up-bit: 0
Metric: 10 IP-Internal 192.85.1.0/24 Up-bit: 0
Metric: 10 IS RX.01
Metric: 10 IS RX.02