Brocade BigIron RX Series Configuration Guide - Manual (Page 793)

BigIron RX Series Configuration Guide 715
53-1002484-04
Configuring MSDP mesh groups
24
Displaying MSDP information
You can display the following MSDP information:
• Summary information – the IP addresses of the peers, the state of the BigIron RX’s MSDP
session with each peer, and statistics for Keepalive, Source Active, and Notification messages
sent to and received from each of the peers.
• Peer information – the IP address of the peer, along with detailed MSDP and TCP statistics.
• Source Active cache entries – the Source Active messages cached by the BigIron RX.
Displaying summary information
To display summary MSDP information, enter the following command at any level of the CLI.
Syntax: show ip msdp summary
This display shows the following information.
TABLE 117 MSDP summary information
This field... Displays...
Peer Address The IP address of the peer’s interface with the BigIron RX
State The state of the MSDP router’s connection with the peer. The state can
be one of the following:
•
CONNECTING – The session is in the active open state.
•
ESTABLISHED – The MSDP session is fully up.
•
INACTIVE – The session is idle.
•
LISTENING – The session is in the passive open state.
KA In The number of MSDP Keepalive messages the MSDP router has
received from the peer
KA Out The number of MSDP Keepalive messages the MSDP router has sent to
the peer
SA In The number of Source Active messages the MSDP router has received
from the peer
SA Out The number of Source Active messages the MSDP router has sent to the
peer
NOT In The number of Notification messages the MSDP router has received
from the peer
NOT Out The number of Notification messages the MSDP router has sent to the
peer
BigIron RX# show ip msdp summary
MSDP Peer Status Summary
KA: Keepalive SA:Source-Active NOT: Notification
Peer Address State KA SA NOT
In Out In Out In Out
206.251.17.30 ESTABLISH 3 3 0 640 0 0
206.251.17.41 ESTABLISH 0 3 651 0 0 0