Brocade BigIron RX Series Configuration Guide - Manual (Page 1398)

1320 BigIron RX Series Configuration Guide
53-1002484-04
Displaying OSPFv3 information
49
To disable the logging of events, enter the following command.
BigIron RX(config-ospf6-router)# no log-status-change
Syntax: [no] log-status-change
To re-enable the logging of events, enter the following command.
BigIron RX(config-ospf6-router)# log-status-change
Displaying OSPFv3 information
You can display the information for the following OSPFv3 parameters:
• Areas
• Link state databases
• Interfaces
• Memory usage
• Neighbors
• Redistributed routes
• Routes
• SPF
• Virtual links
• Virtual neighbors
Displaying OSPFv3 area information
To display global OSPFv3 area information for the Brocade device, enter the following command at
any CLI level.
Syntax: show ipv6 ospf area [<area-id>]
You can specify the <area-id> parameter in the following formats:
• As an IPv4 address, for example, 192.168.1.1
• As a numerical value from 0 – 2,147,483,647
The <area-id> parameter restricts the display to the specified OSPF area
This display shows the following information.
BigIron RX# show ipv6 ospf area
Area 0:
Interface attached to this area: loopback 2 ethe 3/2 tunnel 2
Number of Area scoped LSAs is 6
Statistics of Area 0:
SPF algorithm executed 16 times
SPF last updated: 335256 sec ago
Current SPF node count: 3
Router: 2 Network: 1
Maximum of Hop count to nodes: 2
...