Brocade BigIron RX Series Configuration Guide - Manual (Page 1432)

1354 BigIron RX Series Configuration Guide
53-1002484-04
IPv6 PIM sparse
50
This example show information displayed on a device that is a candidate RP. The following example
shows the message displayed on a device that is not a candidate RP.
BigIron RX# show ipv6 pim rp-candidate
This system is not a Candidate-RP.
Syntax: show ipv6 pim rp-candidate
This display shows the following information.
Displaying RP-to-group mappings
To display RP-to-group-mappings, enter the following command at any CLI level.
BigIron RX# show ipv6 pim rp-map
Idx Group address RP address
--------------------------------------------------------------------------------
1 ff1e::1:2 2001:3e8:255:255::17
2 ff7e:a40:2001:3e8:27:0:1:2 2001:3e8:27::a
3 ff7e:140:2001:3e8:16:0:1:2 2001:3e8:16::1
BigIron RX#
Syntax: show ipv6 pim rp-map
This display shows the following information.
This field... Displays...
Candidate-RP-advertisement in Indicates how many seconds will pass before the BSR sends its next RP
message.
NOTE: This field appears only if this device is a candidate RP.
RP Indicates the IPv6 address of the Rendezvous Point (RP).
NOTE: This field appears only if this device is a candidate RP.
group prefixes Indicates the multicast groups for which the RP listed by the previous field
is a candidate RP.
NOTE: This field appears only if this device is a candidate RP.
Candidate-RP-advertisement period Indicates how frequently the BSR sends candidate RP advertisement
messages.
NOTE: This field appears only if this device is a candidate RP.
This field... Displays...
Index The index number of the table entry in the display.
BigIron RX# show ipv6 pim rp-candidate
Next Candidate-RP-advertisement in 00:00:10
RP: 1be::11:21
group prefixes:
ff00:: / 8
Candidate-RP-advertisement period: 60