Brocade BigIron RX Series Configuration Guide - Manual (Page 819)

BigIron RX Series Configuration Guide 741
53-1002484-04
Configuring IP multicast traffic reduction
24
The source-address parameter specifies the IP address of the multicast source. Each address must
be added or deleted one line per source.
The uplink parameter specifies the port as an uplink port that can receive multicast data for the
configured multicast groups. Upstream traffic will be sent to the switch and will not use a port.
The port-list parameter specifies the range of ports to include in the configuration.
The no form of this command removes the static multicast definition. Each configuration must be
deleted separately.