Brocade BigIron RX Series Configuration Guide User Manual
Page 1353
BigIron RX Series Configuration Guide
1275
53-1002484-04
Displaying BGP4+ information
46
Confederation Peers
The numbers of the local ASs contained in the confederation. This list
matches the confederation peer list you configure on the switch.
Maximum Number of Paths Supported
for Load Sharing
The maximum number of route paths across which the switch can
balance traffic to the same destination. The feature is enabled by
default but the default number of paths is 1. You can increase the
number from 2 – 8 paths.
Number of Neighbors Configured
The number of BGP4+ neighbors configured on this switch.
Number of Routes Installed
The number of BGP4+ routes in the switch’s BGP4+ route table.
To display the BGP4+ route table, refer to
Number of Routes Advertising to All
Neighbors
The total of the RtSent and RtToSend columns for all neighbors.
Number of Attribute Entries Installed
The number of BGP4+ route-attribute entries in the switch’s
route-attributes table. To display the route-attribute table, refer to
“Displaying BGP4+ route-attribute entries”
Neighbor Address
The IPv6 addresses of this switch’s BGP4+ neighbors.
AS#
The AS number.
TABLE 222
BGP4+ summary information (Continued)
This field...
Displays...