Brocade BigIron RX Series Configuration Guide - Manual (Page 1329)

BigIron RX Series Configuration Guide 1251
53-1002484-04
Displaying BGP4+ information
46
NOTE
Portions of this display are truncated for brevity. The purpose of this display is to show all possible
fields that might display rather than to show complete output.
The display shows all the configured parameters for the neighbor. Only the parameters that have
values different from their defaults are shown.
In this example, the number in the far left column indicates the neighbor for which information is
displayed. When you list information for multiple neighbors, this number makes the display easier
to read.
The TCP statistics at the end of the display show status for the TCP session with the neighbor. Most
of the fields show information stored in the switch’s Transmission Control Block (TCB) for the TCP
session between the switch and its neighbor. These fields are described in detail in section 3.2 of
RFC 793, “Transmission Control Protocol Functional Specification”.
Syntax: show ipv6 bgp neighbor [<ipv6-address>]
The <ipv6-address> parameter allows you to display information for a specified neighbor only. You
must specify the <ipv6-address> parameter in hexadecimal using 16-bit values between colons as
documented in RFC 2373.
This display shows the following information:
TABLE 209 BGP4+ neighbor configuration information and statistics
This field... Displays...
IP Address The IPv6 address of the neighbor.
AS The AS in which the neighbor resides.
BigIron RX# show ipv6 bgp neighbor 2000:4::110
1 IP Address: 2000:4::110, AS: 65002 (EBGP), RouterID: 1.1.1.1
State: ESTABLISHED, Time: 5d20h38m54s, KeepAliveTime: 60, HoldTime: 180
RefreshCapability: Received
Messages: Open Update KeepAlive Notification Refresh-Req
Sent : 1 2 8012 0 0
Received: 1 0 7880 0 0
Last Update Time: NLRI Withdraw NLRI Withdraw
Tx: --- --- Rx: --- ---
Last Connection Reset Reason:Unknown
Notification Sent: Unspecified
Notification Received: Unspecified
Neighbor NLRI Negotiation:
Peer Negotiated IPV6 unicast capability
Peer configured for IPV6 unicast Routes
TCP Connection state: ESTABLISHED
Byte Sent: 152411, Received: 149765
Local host: 2000:4::106, Local Port: 8222
Remote host: 2000:4::110, Remote Port: 179
ISentSeq: 740437769 SendNext: 740590181 TotUnAck: 0
TotSent: 152412 ReTrans: 0 UnAckSeq: 740590181
IRcvSeq: 242365900 RcvNext: 242515666 SendWnd: 16384
TotalRcv: 149766 DupliRcv: 0 RcvWnd: 16384
SendQue: 0 RcvQue: 0 CngstWnd: 1440
...