Brocade BigIron RX Series Configuration Guide - Manual (Page 528)

450 BigIron RX Series Configuration Guide
53-1002484-04
Displaying VSRP information
15
Displaying the active interfaces for a VRID
On a VSRP-aware device, you can display VLAN and port information for the connections to the
VSRP devices (Master and Backups) using the show vsrp aware command. The command shows
the active interfaces for the VRID. No output is displayed if the command is entered on a VSRP
master or backup.
Syntax: show vsrp aware
This display shows the following information when you use the aware parameter. For information
about the display when you use the vrid <num> or vlan <vlan-id> parameter, refer to
“Displaying
VRID information” on page 446.
TABLE 91 CLI display of VSRP-aware information
This field... Displays...
VLAN ID The VLAN that contains the VSRP-aware device’s connection with the VSRP
Master and Backups.
VRID The VRID.
Last Port The most recent active port connection to the VRID. This is the port
connected to the current Master. If a failover occurs, the VSRP-aware device
changes the port to the port connected to the new Master. The VSRP-aware
device uses this port to send and receive data through the backed up node.
BigIron RX# show vsrp aware
Aware port listing
VLAN ID VRID Last Port
100 1 3/2
200 2 4/1