Brocade BigIron RX Series Configuration Guide - Manual (Page 1428)

1350 BigIron RX Series Configuration Guide
53-1002484-04
IPv6 PIM sparse
50
Syntax: [no] ssm-enable
Displaying IPv6 PIM-sparse configuration information
To display IPv6 PIM Sparse configuration information, use the show ipv6 pim sparse command as
described in
“Displaying IPv6 PIM-sparse configuration information” on page 1350.
Displaying PIM sparse configuration information and
statistics
You can display the following PIM Sparse information:
• Basic PIM Sparse configuration information
• Group information
• BSR information
• Candidate RP information
• RP-to-group mappings
• RP information for a IPv6 PIM Sparse group
• RP set list
• IPv6 PIM Neighbor information
• The IPv6 PIM flow cache
• The IPv6PIM multicast cache
• IPv6 PIM traffic statistics
• IPv6 PIM counter statistics
Displaying basic PIM sparse configuration information
To display IPv6 PIM Sparse configuration information, enter the following command at any CLI level.
Syntax: show ipv6 pim sparse
This display shows the following information.
BigIron RX#show ipv6 pim sparse
Global PIM Sparse Mode Settings
Hello interval : 30 Neighbor timeout : 105
Bootstrap Msg interval : 60 Candidate-RP Advertisement interval: 60
Register Suppress interval: 60 Register Stop Delay : 60
Join/Prune interval : 60 SPT Threshold : 1
Inactivity interval : 180 SSM Enabled : Yes