Brocade BigIron RX Series Configuration Guide - Manual (Page 878)

800 BigIron RX Series Configuration Guide
53-1002484-04
Displaying OSPF information
26
Syntax: show ip ospf interface [<ip-addr>]
The <ip-addr> parameter displays the OSPF interface information for the specified IP address.
The following table defines the highlighted fields shown in the above example output of the show ip
ospf interface command.
TABLE 127 Output of the show ip ospf interface command
This field Displays
IP Address The IP address of the interface.
OSPF state ptr2ptr (point to point)
Pri The link ID as defined in the router-LSA. This value can be one of the
following:
1 = point-to-point link
3 = point-to-point link with an assigned subnet
Cost The configured output cost for the interface.
Options OSPF Options (Bit7 - Bit0):
•
unused:1
•
opaque:1
•
summary:1
•
dont_propagate:1
•
nssa:1
•
multicast:1
•
externals:1
•
tos:1
Type The area type, which can be one of the following:
•
Broadcast = 0x01
•
Point to Point = 0x03
•
Virtual Link = 0x04
Events OSPF Interface Event:
•
Interface_Up = 0x00
•
Wait_Timer = 0x01
•
Backup_Seen = 0x02
•
Neighbor_Change = 0x03
•
Loop_Indication = 0x04
•
Unloop_Indication = 0x05
•
Interface_Down = 0x06
•
Interface_Passive = 0x07
BigIron RX# show ip ospf interface 192.168.1.1
Ethernet 2/1,OSPF enabled
IP Address 192.168.1.1, Area 0
OSPF state ptr2ptr, Pri 1, Cost 1, Options 2, Type pt-2-pt Events 1
Timers(sec): Transit 1, Retrans 5, Hello 10, Dead 40
DR: Router ID 0.0.0.0 Interface Address 0.0.0.0
BDR: Router ID 0.0.0.0 Interface Address 0.0.0.0
Neighbor Count = 0, Adjacent Neighbor Count= 1
Neighbor: 2.2.2.2
Authentication-Key:None
MD5 Authentication: Key None, Key-Id None, Auth-change-wait-time 300