Brocade BigIron RX Series Configuration Guide - Manual (Page 1341)

BigIron RX Series Configuration Guide 1263
53-1002484-04
Displaying BGP4+ information
46
Syntax: show ipv6 bgp neighbor <ipv6-address> received-routes [detail]
The <ipv6-address> parameter displays route information received from a specified neighbor. You
must specify this address in hexadecimal using 16-bit values between colons as documented in
RFC 2373.
The detail keyword displays detailed route information. If you do not specify this parameter, a
summary of route information displays.
This display shows the following information:
TABLE 215 Summary of route information received from a BGP4+ neighbor
This field... Displays...
Number of BGP4+ Routes received
from a neighbor The number of routes displayed by the command.
Status codes A list of the characters the display uses to indicate the route’s status.
The status code appears in the Status column of the display. The status
codes are described in the command’s output.
Prefix The received route’s prefix.
Next Hop The IPv6 address of the next switch that is used when forwarding a
packet to the received route.
Metric The value of the route’s MED attribute. If the route does not have a
metric, this field is blank.
LocPrf The degree of preference for the advertised route relative to other routes
in the local AS. When the BGP4+ algorithm compares routes on the
basis of local preferences, the route with the higher local preference is
chosen. The preference can have a value from 0 – 4294967295.
BigIron RX# show ipv6 bgp neighbor 2:2:2:2:: received-routes
There are 4 received routes from neighbor 2:2:2:2::
Searching for matching routes, use ^C to quit...
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST C:CONFED_EBGP D:DAMPED
E:EBGP H:HISTORY I:IBGP L:LOCAL M:MULTIPATH S:SUPPRESSED F:FILTERED
PrefixNext HopMetricLocPrfWeightStatus
1 2002::/642:2:2:2:: 01000BE
AS_PATH: 400
2 2003::/642:2:2:2:: 11000BE
AS_PATH: 400
3 2004::/642:2:2:2:: 11000BE
AS_PATH: 400
4 2005::/642:2:2:2:: 11000BE
AS_PATH: 400