Brocade BigIron RX Series Configuration Guide User Manual
Page 1524
1446
BigIron RX Series Configuration Guide
53-1002484-04
Multicast (IP)
E
report-interval
<
10-2000>
“Enabling DVMRP on an interface”
route-discard-timeout
<
40-8000>
“Modifying route discard time”
route-expire-timeout
<
20-4000>
“Modifying route expires time”
router dvmrp
“Globally enabling and disabling DVMRP”
router pim
“Globally enabling and disabling PIM”
“Configuring global PIM Sparse parameters”
rp-address
<
ip-addr>
“Statically specifying the RP”
rp-candidate add I delete
<
group-addr>
<
mask-bits>
rp-candidate ethernet
<
slot>/
<
portnum> | loopback
<
num> | ve
<
num>
show ip pim | dvmrp rpf
<
IP address>
“Displaying information about an upstream neighbor
device”
“Displaying information about an upstream neighbor
device”
show ip pim bsr
show ip pim dense
show ip pim group
“Displaying a list of multicast groups”
show ip pim mcache
“Displaying the PIM multicast cache”
show ip pim nbr
“Displaying multicast neighbor information”
show ip pim rp-candidate
“Displaying candidate RP information”
show ip pim rp-hash
<
group-addr>
“Displaying RP information for a PIM Sparse group”
show ip pim rp-map
“Displaying RP-to-group mappings”
show ip pim rp-set
show ip pim sparse
“Displaying basic PIM Sparse configuration
information”
show ip pim traffic
“Displaying PIM traffic statistics”
spt-threshold infinity |
<
num>
“Changing the Shortest Path Tree (SPT) threshold”
system-max dvmrp-mcache
<
num>
“Defining the maximum number of DVMRP cache
entries”
system-max pim-mcache
<
num>
“Defining the maximum number of PIM cache
entries”
trigger-interval
<
5-30>
Commands
See ...