Configuring rip, Overview of routing information protocol (rip), Configuring rip parameters – Brocade BigIron RX Series Configuration Guide User Manual
Page 821: Chapter 25
BigIron RX Series Configuration Guide
743
53-1002484-04
Chapter
25
Configuring RIP
In this chapter
•
Overview of Routing Information Protocol (RIP). . . . . . . . . . . . . . . . . . . . . . 743
•
•
Overview of Routing Information Protocol (RIP)
Routing Information Protocol (RIP) is an IP route exchange protocol that uses a distance vector (a
number representing distance) to measure the cost of a given route. The cost is a distance vector
because the cost often is equivalent to the number of router hops between the device and the
destination network.
A device can receive multiple paths to a destination. The software evaluates the paths, selects the
best path, and saves the path in the IP route table as the route to the destination. Typically, the best
path is the path with the fewest hops. A hop is another router through which packets must travel to
reach the destination. If the device receives a RIP update from another router that contains a path
with fewer hops than the path stored in the device’s route table, the device replaces the older route
with the newer one. The device then includes the new path in the updates it sends to other RIP
routers, including the device.
RIP routers, including the BigIron RX, also can modify a route’s cost, generally by adding to it, to
bias the selection of a route for a given destination. In this case, the actual number of router hops
may be the same, but the route has an administratively higher cost and is thus less likely to be
used than other, lower-cost routes.
A RIP route can have a maximum cost of 15. Any destination with a higher cost is considered
unreachable. Although limiting to larger networks, the low maximum hop count prevents endless
loops in the network.
Configuring RIP parameters
Use the following procedures to configure RIP parameters on a system-wide and individual
interface basis.