Brocade BigIron RX Series Configuration Guide - Manual (Page 49)

BigIron RX Series Configuration Guide xlix
53-1002484-04
Enhanced command to
display stp/rstp/mstp
information for a
particular Ethernet
interface The show xstp command is newly added. It
displays the stp/rstp/mstp protocol
information of a particular Ethernet interface. Book: BigIron RX Series
Configuration Guide
Chapter:
“Configuring Spanning Tree
Protocol”
Section: “Displaying STP information
for the specified Ethernet interface”
Chapter: “Configuring Rapid
Spanning Tree Protocol”
Section: “Displaying RSTP
information for the specified
Ethernet interface”
Chapter: “Multiple Spanning Tree
Protocol (MSTP) 802.1s”
Section: “Displaying MSTP
information for the specified
Ethernet interface”
Copy software image
from a flash card to the
flash memory In Release 02.8.00 of the Multi-Service
IronWare software, new copy command have
been added to copy software image from a
flash card to the flash memory. Book: BigIron RX Series
Configuration Guide
Chapter:
“Using a Redundant
Management Module”
Section: “Copying software image
from a flash card to the flash
memory”
Continuous System
Monitoring (Sysmon) Continuous system monitoring (Sysmon) is
implemented in BigIron RX to monitor the
overall system’s health. It monitors different
system components of a router or a switch to
determine if those components are operating
correctly. Book: BigIron RX Series
Configuration Guide
Chapter:
“Continuous System
Monitor”
Enhancement in ACL
Support Brocade RX devices now support IPv4 and IPv6
ACLs on the same interface Book: BigIron RX Series
Configuration Guide
TABLE 4 Summary of enhancements in release 02.8.00 (Continued)
Enhancement Description See page