Brocade BigIron RX Series Configuration Guide User Manual
Page 1196
1118
BigIron RX Series Configuration Guide
53-1002484-04
Basic management
39
<value> packets input, <value> bytes,
<value> no buffer
•
The <value> packets input variable specifies the number of
packets received.
•
The <value> bytes variable specifies the number of bytes
received.
•
The <value> no buffer variable specifies the number of packets
with no buffer.
Received <value> broadcasts, <value>
multicasts, <value> unicasts
The <value> variable specifies the amount of traffic the interface
module is receiving on broadcasts, multicasts, and unicast traffic.
<value> input errors, <value> CRC,
<value> frame, <value> ignored
•
The <value> input errors variable specifies the number of
received packets with errors.
•
The <value> CRC variable specifies the number of received
packets with CRC errors.
•
The <value> frame variable specifies the number of received
packets with alignment errors.
•
The <value> ignored variable specifies the number of received
packets that are discarded.
<value> runts, <value> giants, DMA
received <value> packets
•
The <value> runts variable specifies the number of small packets
that are less than 64 bytes.
•
The <value> giants variable specifies the number of large
packets greater than 1518 bytes.
•
The DMA received <value> packets variable specifies the number
of DMA received packets.
<value> packets output, <value> bytes,
<value> underruns
•
The <value> packets output variable specifies the number of
packets transmitted.
•
The <value> bytes variable specifies the number of bytes
transmitted.
•
The <value> underruns variable specifies the number of packets
that underruns.
Transmitted <value> broadcasts,
<value> multicasts, <value> unicasts
The <value> variable specifies the amount of traffic the interface
module transmitted on broadcasts, multicasts, and unicast traffic.
<value> output errors, <value>
collisions, DMA transmitted <value>
packets
•
The <value> output errors variable specifies the number of
transmitted packets with errors.
•
The <value> collisions variable specifies the number of
transmitted packets with collision errors.
•
The DMA transmitted <value> packets variable specifies the
number of DMA transmitted packets.
Port Translation counter <value>
The <value> variable specifies the total number of port translation
events.
Port UP counter <value>
The <value> variable specifies the total number of times port state
change from down to up.
Port Down Counter <value>
The <value> variable specifies the total number of times port state
change from up to down.
TABLE 182
Output parameters of show interfaces command (Continued)
This field...
Displays...