Brocade BigIron RX Series Configuration Guide - Manual (Page 991)

BigIron RX Series Configuration Guide 913
53-1002484-04
Displaying BGP4 information
27
Displaying route information for a neighbor
You can display routes based on the following criteria:
• A summary of the routes for a specific neighbor.
• The routes received from the neighbor that the device selected as the best routes to their
destinations.
• The routes received from the neighbor that are the best BGP4 routes to their destinations, but
were nonetheless not installed in the IP route table because the device received better routes
from other sources (such as OSPF, RIP, or static IP routes).
• The routes that are unreachable because the device does not have a valid RIP, OSPF, or static
route to the next hop.
• Routes for a specific network advertised by the device to the neighbor.
• The Routing Information Base (RIB) for a specific network advertised to the neighbor. You can
display the RIB regardless of whether the device has already sent it to the neighbor.
Displaying summary route information
To display summary route information, enter a command such as the following at any level of the
CLI.
TotalRcv The number of sequence numbers received from the neighbor.
DupliRcv The number of duplicate sequence numbers received from the neighbor.
RcvWnd The size of the receive window.
SendQue The number of sequence numbers in the send queue.
RcvQue The number of sequence numbers in the receive queue.
CngstWnd The number of times the window has changed.
TABLE 138 BGP4 neighbor information (Continued)
This field... Displays...
BigIron RX(config-bgp)# show ip bgp neighbor 10.1.0.2 routes-summary
1 IP Address: 10.1.0.2
Routes Accepted/Installed:1, Filtered/Kept:11, Filtered:11
Routes Selected as BEST Routes:1
BEST Routes not Installed in IP Forwarding Table:0
Unreachable Routes (no IGP Route for NEXTHOP):0
History Routes:0
NLRIs Received in Update Message:24, Withdraws:0 (0), Replacements:1
NLRIs Discarded due to
Maximum Prefix Limit:0, AS Loop:0
Invalid Nexthop:0, Invalid Nexthop Address:0.0.0.0
Duplicated Originator_ID:0, Cluster_ID:0
Routes Advertised:0, To be Sent:0, To be Withdrawn:0
NLRIs Sent in Update Message:0, Withdraws:0, Replacements:0
Peer Out of Memory Count for:
Receiving Update Messages:0, Accepting Routes(NLRI):0
Attributes:0, Outbound Routes(RIB-out):0