Brocade BigIron RX Series Configuration Guide - Manual (Page 588)

510 BigIron RX Series Configuration Guide
53-1002484-04
Configuring multicast traffic engineering
18
NOTE
The configurations for group port 1 will now be associated to s/1,s/5,s/9,s/13
3. To set the group port 2 weight, low prioriy traffic,
BigIron RX(config-if-e10000-4/1)# qos scheduler destination-weighted 1 2 1
4. To set the group port 2 weight, high prioriy traffic,
BigIron RX(config-if-e10000-4/1)# qos scheduler destination-weighted 1 2 1 2
NOTE
The configurations for group port 2 will now be associated to s/2,s/6,s/10,s/14
5. To set the group port 3 weight, low prioriy traffic,
BigIron RX(config-if-e10000-4/1)# qos scheduler destination-weighted 1 2 1 2 1
6. To set the group port 3 weight, high prioriy traffic,
BigIron RX(config-if-e10000-4/1)# qos scheduler destination-weighted 1 2 1 2 1
2
NOTE
The configurations for group port 3 will now be associated to s/3,s/7,s/11,s/15
7. To set the group port 4 weight, low prioriy traffic,
BigIron RX(config-if-e10000-4/1)# qos scheduler destination-weighted 1 2 1 2 1
2 1
8. To set the group port 4 weight, high prioriy traffic,
BigIron RX(config-if-e10000-4/1)# qos scheduler destination-weighted 1 2 1 2 1
2 1 2
NOTE
The configurations for group port 4 will now be associated to s/4,s/8,s/12,s/16
Use rcv-scheduler to change the receive scheduling parameters on the 16x10G card.
Use scheduler to assign a scheduling mechanism to one or more ports.
Use the no parameter to return to the default mode. (Server)
Use the num parameter to set the port weight.