Brocade BigIron RX Series Configuration Guide - Manual (Page 214)

136 BigIron RX Series Configuration Guide
53-1002484-04
Displaying the full port name for an interface
5
1/9 Disabled None None No 001b.ed24.3a00
1/10 Up Forward 1G No 001b.ed24.3a00
1/11 Disabled None None No 001b.ed24.3a00
1/12 Disabled None None No 001b.ed24.3a00
(output truncated for brevity)...
Syntax: show interface brief wide [ethernet <slot/port> | loopback | management | slot | tunnel
| ve]
The ethernet <slot/port> parameter specifies the Ethernet port for which you want to display the
interface information.
The loopback option specifies the loopback port for which you want to display the interface
information.
The management option specifies the management port for which you want to display the interface
information.
The slot option specifies all the ports in a slot for which you want to display the interface
information.
The tunnel option specifies the tunnel port for which you want to display the interface information.
The ve option specifies the virtual routing (VE) port for which you want to display the interface
information.
Table 45 describes the output parameters of the show interface brief wide command.
To display the complete port name for an Ethernet interface, enter a command such as the
following.
BigIron RX# show interface brief wide ethernet 1/2
Port Link Port-State Speed Tag MAC Name
1/2 Up LACP-BLOCKED Auto Yes 001b.ed24.3a00 this is a long port
nameqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqq
qqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqq
qqqqqqqqqqqqqqqq
Syntax: show interface brief wide ethernet <slot/port>
For more information about field descriptions of the command output, refer to Table 45.
TABLE 45 Output parameters of the show interface brief wide command
Field Description
Port Specifies the port number.
Link Specifies the link state.
Port-State Specifies the current port state.
Speed Specifies the link speed.
Tag Specifies if the port is tagged or not.
MAC Specifies the MAC address.
Name Specifies the port name.