HP StorageWorks XP Remote Web Console Software - Manual (Page 110)

Table 27 Journal Operation Window Details – List (continued)
Description Item
to the remote command device, and the mirror ID is 00, all columns other than mirror ID and remote
command device are blank.
•
JNLG (LDKC): Indicates the number of a journal group in the local storage system, and the LDKC
number enclosed in parentheses.
•
Attribute: Indicates the attribute of a journal group in the local storage system. When this column
is blank, neither journal volumes nor data volumes are registered in this journal group.
• Status: Indicates the status of a journal group in the local storage system.
Initial: A journal group in initial status. Journal volumes are registered in this journal group,
but no data volumes (primary data volumes or secondary data volumes) are registered in this
journal group. Creating a Universal Replicator for Mainframe volume pair registers data volumes
in a journal group. The status of the journal group changes to Active.
Active: Either of the following:
◦ Initial copy is in progress. The primary data volume and the secondary data volume are not
synchronized.
◦ Initial copy is finished. The primary data volume and the secondary data volume are
synchronized.
If a journal group is in Active status, some of the data volume pairs in the journal group might be
split. If this happens, a Warning appears. To restore such data volume pairs, use the Pair Operation
window.
HaltAccept: An operation for splitting the mirror has been started. The status of the journal
group will immediately change to Halting. HaltAccept can indicate the status of restore journal
groups, but cannot indicate the status of master journal groups.
Halting: An operation for splitting or deleting the mirror is in progress. The
primary data volume and the secondary data volume are not synchronized.
Splitting a mirror changes the status in the following order: Halting, Halt, Stopping,
and finally Stop. Deleting a mirror changes the status in the following order:
Halting, Halt, Stopping, Stop, and finally Initial.
Halt: An operation for splitting or deleting the mirror is in progress. The primary
data volume and the secondary data volume are not synchronized.
Stopping: An operation for splitting or deleting the mirror is in progress. The
primary data volume and the secondary data volume are not synchronized.
Stop: An operation for splitting the mirror is finished or in progress. The primary
data volume and the secondary data volume are not synchronized.
Hold: A Universal Replicator for Mainframe pair for the delta resync operation
is created.
: An error occurred with the Universal Replicator for Mainframe pair for the
delta resync operation.
Holding: A Universal Replicator for Mainframe pair for delta resync operation
is being created.
Hold (Failure)
110 Using the Universal Replicator for Mainframe GUI