HP StorageWorks XP Remote Web Console Software - Manual (Page 144)

NOTE: If an error occurs, the right-most column of the Preview list displays the error code.
To view detailed information about the error, right-click the error code and then select Error
Detail. An error message appears and gives you detailed information about the error.
If the URz pair which is being deleted exsists in the primary storage system, perform the pair
creation after the pair status changes to Simplex.
Figure 65 Add DKC Window
The Add DKC window displays the following settings:
•
S/N: allows you to enter the five-digit serial number of the remote storage system.
•
LDKC: allows you to enter the LDKC number of the remote storage system. 00 is displayed
when the remote storage system is an XP12000/XP10000 or XP24000/XP20000 Disk Array.
NOTE: The LDKC#01 cannot be used in this version.
•
Controller ID: allows you to enter the controller ID (model name that indicates the model) of
the remote storage system. The controller ID for an XP24000/XP20000 Disk Array is
5(XP24000/XP20000).
•
Path Gr. ID: allows you to enter the path group ID. Path group IDs are used for identifying
groups of logical paths. One path group can contain up to eight logical paths.
Path group IDs are within the range of 1-FF (hexadecimal). If you select the Default check box,
the default path group ID will be set.
NOTE: In the current version, you cannot enter path group IDs. Also, you cannot clear the
Default check box. The number of path group IDs per one remote storage system is always
1.
144 Configuring Storage Systems and Logical Paths