HP StorageWorks XP Remote Web Console Software - Manual (Page 147)

7. Use the Add Path window to configure new logical paths.
Up to eight paths can be configured.
8. Click Set to close the Add Path window.
9. See the Preview list to check the settings that you have made.
•
To modify a setting, select and right-click the setting from the Preview list and then select
Modify. A window appears and allows you to modify the setting.
•
To cancel a setting, select and right-click the setting in the Preview list and then select
Cancel.
10. Click Apply to apply the settings that you have made.
NOTE: If an error occurs, the right-most column of the Preview list displays the error code.
To view detailed information about the error, right-click the error code and then select Error
Detail. An error message appears and gives you detailed information about the error.
Figure 67 Add Path Window
The Add Path window displays the following settings:
•
Port: Allows you to select an initiator port on the local storage system.
NOTE: When specifying a port, you can use the keyboard to enter the port number. When
you enter the port number, you can abbreviate the port number to two characters. For example,
you can enter 1A instead of CL1-A. You can use uppercase and lowercase letters.
•
Pair-Port: Allows you to select an RCU target port on the remote storage system.
NOTE: When specifying a port, you can use the keyboard to enter the port number. When
you enter the port number, you can abbreviate the port number to two characters. For example,
you can enter 1A instead of CL1-A. You can use uppercase and lowercase letters.
•
Set: Closes the Add Path window and adds the settings to the Preview list.
•
Cancel: cancels the settings and closes the Add Path dialog box.
Adding Logical Paths 147