HP StorageWorks XP Remote Web Console Software User Manual
Page 209
The table below shows the parameters and detailed information for the settings for AddPair tag.
Table 44 AddPair Tag Parameters and Settings
Range/Character numbers
Description setting
Parameter
Column
00 to 01
LDKC number of the primary data volume
LDKC
A
00 to FE
CU number of the primary data volume
CU
B
00 to FF
LDEV number of the primary data volume
LDEV
C
00 to 01
LDKC number of the secondary data volume
LDKC(S)
D
00 to FE
CU number of the secondary data volume
CU(S)
E
00 to FF
LDEV number of the secondary data volume
LDEV(S)
F
00 to 03
Mirror ID
MirrorID
G
00 to FF
ID number of the master journal group
M-JNL
H
00 to FF
ID number of the remote journal group
R-JNL
I
00000 to 99999
Serial number of the secondary storage system
DKCSN
J
4 to 7
Controller ID of the secondary storage system
ControllerID
K
00
Path group ID
PathGroup
L
N/A
CopyMode
M
•
Entire: Initial copy operation will be executed.
•
None: Initial copy operation will not be executed.
•
Delta: Without executing the initial copy operation,
a pair for delta resync operation will be created.
1 to 256
1
Priority of the operation
Priority
N
N/A
ErrorLevel
O
•
Group: When a failure occurs, all the pairs in the
same mirror will be split.
•
Volume: When a failure occurs, only the specified
pair will be split.
N/A
CFW
P
•
Only_P-VOL: Cache-fast-write data will not be copied
to the secondary data volume.
•
Copy_to_S-VOL: Cache-fast-write data will be copied
to the secondary data volume.
1
When creating a pair, a smaller priority number indicates a higher priority. When creating many pairs at a time,
specifying the Priority parameter may not be enough to manage the priority of pair creation. To be assured of establishing
priority for specified pairs, HP recommends separate spreadsheets for high-priority pairs and other pairs.
NOTE:
It is possible to create a Universal Replicator for Mainframe pair for delta resync operation
using a spreadsheet, but Business Continuity Manager is still required to use the delta resync
function. Therefore, it is easier to only use Business Continuity Manager to create pairs for delta
resync operations.
After pairs are created, information about those pairs can be retrieved using the Pair tag. This pair
information will be useful for future operations.
Here is an example:
1.
Use the AddPair tag to create Universal Replicator for Mainframe pairs.
2.
Retrieve the pair information of the Universal Replicator for Mainframe pairs by using the Pair
tag. The pair information is formatted as follows:
Output example
#!Version 05_02_01, CLI_RemoteCopyJournalMG, Get,;
[Pair]
Creating Pairs (AddPair Tag) 209