HP StorageWorks XP Remote Web Console Software - Manual (Page 167)

◦ S/N(LDKC): Indicates the serial number and the LDKC number of the remote storage
system.
This column is blank if the attribute of the journal group is neither Master nor Restore.
◦ Pair JNLG: Indicates the number of a journal group in the remote storage system.
This column is blank if the attribute of the journal group is neither Master nor Restore.
◦ Controller ID: Indicates the controller ID (model name that indicates the model) of the
remote storage system. The controller ID for an XP24000/XP20000 Disk Array is 5.
This column is blank if the attribute of the journal group is neither Master nor Restore.
◦ Path Watch Time: Indicates the time for monitoring the blockade of paths to the remote
storage system. If the status of the mirror where secondary data volumes in a local storage
system are registered is Hold, Holding, or Hold(Failure), this column is blank.
◦ Volume: Indicates the number of data volumes that are registered in the mirror.
◦ Capacity: Indicates the total capacity of data volumes that are registered in the mirror.
◦ Remote Command Device: Displays LDEV numbers if the remote command device is
assigned to the mirror. This column is blank if the remote command device is not assigned
to the mirror.
•
Previous: Displays detailed information about the previous journal group.
•
Next: Displays detailed information about the next journal group.
•
Close: Closes the JNL Group Detail window.
Changing Options for a Journal Group
To change the options for a journal group, follow the procedure below. Both the primary storage
system administrator and the secondary storage system administrator must perform this operation.
1. Ensure that the Remote Web Console main window is in Modify mode.
For detailed information about how to do this, see the HP XP24000/XP20000 Remote Web
Console User's Guide.
2. Ensure that the Journal Operation window is displayed.
Changing Options for a Journal Group 167