HP StorageWorks XP Remote Web Console Software - Manual (Page 213)

Table 47 DeletePair Tag Parameters and Settings (continued)
Range/Character numbers Setting Parameter Column
N/A Range
2
H •
Group: all of the pairs in the same mirror will be
released.
• Volume: only the specified pair in the mirror will be
released.
N/A DeleteMode 3 I •
Normal: pair will be released only when the pair
status can be changed to Simplex in the primary
storage system.
• Force: under any condition, pair will be forcibly
released in the site on which the operation is
performed.
1
When the specified volume type (primary or secondary) in VolType is different from the actual volume type, the spreadsheet
operation will end normally but the pair will not be released.
2 If Group and multiple Universal Replicator for Mainframe pairs are specified in the same spreadsheet, an error occurs.
3
You must specify Group for Range if you specify Force. If you do not, the spreadsheet operation may end normally but
the pair will not be released. Also, if you specify Force for volumes other than Universal Replicator for Mainframe pairs,
no error will occur but in this case the pair will again not be released.
Save time by using the pair information to write the parameters of the DeletePair tag. For details
see
“Pair Tag Parameters and Contents” (page 208) .
Releasing Pairs (DeletePair Tag) 213