HP StorageWorks XP Remote Web Console Software User Manual
Page 138
•
Delete logical paths
•
Display status of logical paths
•
Delete the relationship between the primary and the secondary storage systems
NOTE:
•
Throughout this chapter, the primary and the secondary storage systems are sometimes referred
to as local storage systems or remote storage systems. If you are logged into the primary
storage system and are using Universal Replicator for Mainframe, the primary storage system
is a local storage system and the secondary storage system is a remote storage system. If you
are logged into the secondary storage system and are using Universal Replicator for Mainframe,
the secondary storage system is a local storage system and the primary storage system is a
remote storage system.
•
When performing system configuration, the administrator also needs to configure journal
groups. For detailed information about configuring journal groups, see
Setup Procedure for Multiple Primary and Secondary Storage Systems
After you have installed the Universal Replicator for Mainframe hardware and software, you can
configure the primary storage systems and secondary storage systems for Universal Replicator for
Mainframe operations.
To configure the primary storage systems and secondary storage systems for Universal Replicator
for Mainframe operations:
1.
Identify the volumes that will become the Universal Replicator for Mainframe data volumes
and journal volumes in the primary storage system and secondary storage system. You need
to know the storage system S/N and the controller ID, so that you can configure the primary
storage systems and secondary storage systems correctly for your desired pairs. When you
create the pairs, you will need to know the LDKC number, the CU number, and the LDEV
number of each volume.
2.
Connect to the storage system that you want to use. For further information on Remote Web
Console installation and operations, see the HP XP24000/XP20000 Remote Web Console
User's Guide, or contact your HP support representative. Operate at a primary storage system
and a secondary storage system.
NOTE:
You must log in with Administrator or Universal Replicator for Mainframe write access,
and you must be in Modify mode. If you are in the View mode, you can see the Universal
Replicator for Mainframe pair status, but you cannot modify the settings.
3.
When you select Go, Universal Replicator for Mainframe and then URz Monitor on the menu
bar of the Remote Web Console main window, Universal Replicator for Mainframe starts and
the Universal Replicator for Mainframe window is active. Operate at a primary storage system
and a secondary storage system.
4.
Select the Port radio button on the DKC Operation window, and set the initiator and RCU
target ports. Operate at a primary storage system and a secondary storage system.
5.
Select the DKC radio button on the DKC Operation window to display the Add DKC window.
Set the S/N of the storage system which will be connected, the controller ID, the path group
ID, the initiator port in this storage system, and the RCU target port in the storage system which
will be connected. Operate at a primary storage system and a secondary storage system.
6.
Click Option on the Add DKC window, and then set the desired options of the local storage
system. Operate at a primary storage system and a secondary storage system.
7.
Specify the journal group number from the Journal Operation window. Register the journal
volumes from the Edit JNL Volumes window. Operate at a primary storage system and a
secondary storage system.
138
Configuring Storage Systems and Logical Paths