HP StorageWorks XP Remote Web Console Software User Manual
Page 180
12.
Select ->Add.
The selected journal groups move to the JNLG list on the right.
NOTE:
If the JNLG list on the right contains any journal group that you do not want to register,
select the journal group from the list and then click <-Cancel.
13.
From Mirror ID, select a mirror ID.
NOTE:
If a mirror ID is already specified and unchangeable, you do not need to select it.
14.
If necessary, repeat steps
to
.
15.
Select Set to close the Add JNL Group window.
16.
See the Preview list to check the settings that you have made.
NOTE:
To modify a setting, select and right-click the setting in the Preview list and then select
Modify. A window appears and allows you to modify the setting.
17.
Click Apply to register the journal groups.
NOTE:
If an error occurs, the right-most column of the Preview list displays the error code.
To view detailed information about the error, right-click the error code and then select Error
Detail. An error message appears and gives you detailed information about the error.
Figure 77 Add JNL Group Window
The Add JNL Group window displays the following settings:
•
JNLG of the local DKC is used in check box ON: Allows you to specify whether to register
journal groups of the supervisor DKC by selecting the check box at the far left of the DKCs
(DKC-1 to DKC-4).
The check box is selected on DKC-1 by default. Clear this check box if you do not want to
register journal groups of the supervisor DKC.
•
DKC-1 to DKC-4: Note that even if the extended consistency group uses more than four storage
systems, the dialog box shows only up to the fourth storage system. The complete extended
consistency group configuration can be seen using XP for Business Continuity Manager
Software.
•
S/N(LDKC): Allows you to specify the serial number of a storage system.
180 Using Extended Consistency Groups