HP StorageWorks XP Remote Web Console Software User Manual
Page 188
9.
Do one of the following to make settings on the initial copy operation:
•
Select Entire if you want to start the initial copy operation immediately after the pair is
created.
•
Select None if you do not want to start the initial copy operation immediately after the
pair is created.
•
Select Delta if you want to create a Universal Replicator for Mainframe pair for the delta
resync operation.
NOTE:
To create a Universal Replicator for Mainframe pair for the delta resync
operation, you must meet the requirements listed in
“Requirements for Creating Universal
Replicator for Mainframe Pair for the Delta Resync Operation” (page 87)
.
10.
Use Error Level to specify the range used for splitting a pair when a failure occurs.
11.
Use CFW to specify whether to copy cache-fast-write data to the secondary data volume.
12.
Click Set to close the Add Pair window.
13.
See the Preview list in the Pair Operation window to check the settings that you have made.
•
To modify a setting, select and right-click the setting and then select Modify.
•
To cancel a setting, select and right-click the setting and then select Cancel.
14.
Click Apply to start the pair creation and the initial copy operation.
NOTE:
If an error occurs, the right-most column of the Preview list displays the error code.
To view detailed information about the error, right-click the error code and then select Error
Detail. An error message appears and gives you detailed information about the error.
If the URz pair which is being deleted exsists in the primary storage system, perform the pair
creation after the pair status changes to Simplex.
15.
In the list of the Pair Operations window, verify that the status of the pair is correct.
If you selected Entire or None in step
, the status of the pair is either Pending or Duplex. If
you selected Delta, the status of the pair is Hold or Holding.
16.
To monitor the progress of the Add Pair operation(s), click File, Refresh on the menu bar of
the Remote Web Console main window to update the information in the list, or use the Detailed
Information window (see
“Detailed Information Window” (page 192)
) to monitor the detailed
status of each pair.
188 Performing Pair Operations