IDEX Health & Science VS-606V7 Series User Manual

Page 133

Advertising
background image

133

Protective
Operation

Output is shut
OFF and motor
coasts to a
stop.

OC (Over current)
Inverter output current
momentarily exceeds approx.
250% of rated current.

• Short circuit or

grounding at inverter
output side.

• Excessive load WK

2

• Extremely rapid

accel/decel time
(parameters n019 to
n022)

• Special motor used
• Starting motor during

coasting

• Motor of a capacity

greater than the
inverter rating has
been started.

• Magnetic contactor

open/closed at the
inverter output side.

(Load Short-circuit)*
The Inverter output or load
was short circuited.

A short-circuit or
ground fault.

Reset the fault
correcting its cause.

(Ground Fault)*
The ground fault current at the
Inverter output exceeded
approximately 50% of the
Inverter rated output current.

A ground fault occurred
at the Inverter output.

Reset the fault after
correcting its cause.

OV (Main circuit over voltage)
Main circuit DC voltage
exceeds the overfatigue
detection level because of
excessive regenerative
energy from the motor.
Detection level:
200V: Stops at main circuit

DC voltage below
approx. 410V

400V: Stops at main circuit

DC voltage approx.
820V or more

• Insufficient decel

time (parameters
n020 and n022)

• Lowering of minus

load (elevator, etc.)

• Increase decel time.
• Connect optional

braking resistor.

UV1 (Main circuit low voltage)
Main circuit DC voltage drops
below the low voltage
detection level while the
inverter output is ON.
200V: Stops at main circuit

DC voltage below
approx. 200V (160V for
single phase)

400V: Stops at main circuit

DC voltage approx.
400V or more

• Reduction of input

power supply voltage

• Open phase of input

supply

• Occurrence of

momentary power
loss

Check the following:
• Power supply

voltage

• Main circuit power

supply wiring is
connected.

• Terminal screws are

securely tightened.

Alarm Display

Inverter

Status

Explanation

Causes and

Corrective Actions

Digital

Operator

RUN (Green)

ALARM (Red)

* Display only applies to 200/400V class,7.5/10Hp, 5.5/7.5 kW inverters.

Advertising