2N Lift8 v1.6.0 - Manual (Page 118)

118
2N TELEKOMUNIKACE a.s., www.2n.cz
®
087
Insert
specific
character in
fault
reporting
memory
088
Count of
automatic
dialling
cycles for
error call
0–9 3
181–186
Confirmation
mode for
number 1–6
1–6 1
1 = with confirmation DTMF
(1), 2= confirmation of
picking up (supported only
for GSM/UMTS/VoIP), 3 =
CPC Antenna, 4= CPC
KONE, 5 = P100, 6 =
autodetection DTMF
protocol (CPC
Antenna/P100)
If there is no guarantee of
problem-free transfer of
DTMF, do not set 6 for
autodetection CPC
Antenna/P100, but
precisely specify the
protocol to be used (3 or
5).
501
Default
output state
of IO module
1
ABCD empty
The value defines the state
of the I/O modules after
the system start:
A= output 1
B= output 2
C= output 3
D= output 4
0= output off
1= output on
Example: 1001= outputs 1
502
Default
output state
of IO module
2
ABCD empty
503
Default
output state
of IO module
3
ABCD empty
504
Default
output state
of IO module
4
ABCD empty
505
Default
output state
of IO module
5
ABCD empty
506
Default
output state
of IO module
6
ABCD empty