2N Lift8 v1.6.0 - Manual (Page 201)

201
2N TELEKOMUNIKACE a.s., www.2n.cz
®
General
In the menu, you can change the group name in the Name Groups – General
parameter and assign intercoms to a group. You can see a list of all created intercoms
not assigned to the currently displayed group to the right and a list of all intercoms
assigned to the group to the left. You can use the searching function like in the group
list. Select an intercom and click the appropriate arrow to move the intercom to/from a
group. You can use multiselect for selection. Furthermore, the menu provides an
extended setting, which helps you assign all the parameters at once to the given
intercom group. Define the Type of device:
, , 2N LiftNet
®
2N SingleTalk
®
2N Lift8
®
or ; refer to the Intercom Creation subsection above for details. Plan is the Unknown
next parameter: enter the Address of the building where the intercom group is installed
and intercom positions on the plan. This information will then be displayed on the map
for Technicians or Dispatchers to repair the device or navigate the rescue team
respectively. The Check call period defines the timeout for the intercom to check-call
the
. The intercom can call the any time within 2N Lift8
®
Server 2N Lift8
®
Server
this timeout, but having exceeded this value, it will be marked as defective. The
non-functional status will be removed when another check or alarm call arrives in the
server from this intercom. The default value of this parameter is 72 hours. The Alarm
call response specifies the type of alarm call processing:
, Normal call Confirm with
and Similarly, the Check call response specifies 1, CPC Antenna, CPC KONE P100.
the type of check call processing: , , , Reject Accept and send 5 Confirm with 1 a 5
and Click Save to confirm the settings. CPC Antenna, CPC KONE P100.
Users
The menu provides a list of users that are authorised to administer and monitor Users
the intercoms in a group. Administrator may administer all the system intercoms, users
and roles regardless of group assignment. All the users authorised for the selected
group are displayed in the list of Assigned users and next to the intercoms. To add a
user, select the user in the Not assigned users and move it to the Assigned users with
the arrow. To delete a user, select the user in the Assigned users and move it to
the Not assigned users with the arrow key. To search a user, enter the string to be
searched into the field above the list and see the filtration result in the associated list
immediately. Click Save to save the new settings.
Call Server
The helps you configure the SIP lines for the check calls. Configure up Call server CU
to 8 independent telephone lines. The first line is also intended for active check calls
and can be configured via extended settings. Enter the SIP line parameters correctly
for a successful SIP Proxy server registration. Make sure that the lines and servers are
configured correctly to make the Call server work properly. If you use VoIP, obtain the
SIP line settings from your VoIP provider. If you have a SIP Proxy server of your own,
contact your network administrator for correct settings.
Tip
Advanced settings are not required. You can configure all or no
parameters at your discretion.
The advanced parameter list is empty by default. If a parameter is
identically set for all the intercoms, the parameter value will be displayed.
If not, the field will remain empty.