Rechargeable battery connection and state check – 2N Lift8 v1.6.0 User Manual
Page 29
29
Power supply
The
is powered by 100–240V mains power.
CU
Rechargeable Battery Connection and State Check
Procedure:
1. Keep the
disconnected from the mains.
CU
2. Loosen the three screws on the upper cover of the
CU.
3. Move the upper cover of the
in such a way that you can remove it.
CU
4. When removing the cover, proceed with caution, be careful about the earth wire
connecting the cover with the
bottom part. Do not disconnect the wire unless
CU
there is a reason to do so!
5. Interconnect the rechargeable batteries and connect them with the motherboard
using a FASTON cable (see the figure below). Mind the polarity.
6. Replace the upper cover on the
and tighten the cover fitting screws. Doing
CU
so make sure that the earthing wire is connected to the cover!
7. Connect the
power cable to a 230V socket.
CU
After plugging the
into the socket the LED (Power/battery) should start to flash
CU
(charging). The
charges the rechargeable batteries until fully charged. After some
CU
time the flashing green LED (charging) should change to a permanently illuminated
green LED (battery charged).
Warning
Never connect an AC source or unstabilised DC source to avoid CU
damage.