Electrical installation, Description of connectors, Address configuration – 2N Lift8 v1.6.0 User Manual
Page 57
57
Electrical Installation
Description of Connectors
There are 3 connectors to the right under the cover:
Figure: Machine Room Audio Unit Connectors
Address Configuration
There is a group of jumpers u
. Do not use any of them
nder the transparent front cover
if the machine room is only intended for the given lift. The
identifies itself as
audio unit
the machine room for the given lift.
If the machine room is to be shared by multiple lifts, configure the corresponding pins
1–8 for the lifts to share the machine room (numbered 1–8 from left to right 1–8).
Group of 8 jumpers for address configuration: If the machine room is shared by
multiple lifts, use one
and configure several addresses using the
audio unit
included jumpers. The other
types do not have this possibility!
audio unit
Note
This audio unit is always configured as the machine room and cannot have
a different location.
Note
Having set more addresses for the
, press the TRIPHONY button
audio unit
to activate communication of the lift
with the lowest of the
audio units
configured addresses.
Caution
.
Avoid the
address duplicity
audio unit