2N Lift8 v1.6.0 - Manual (Page 95)

95
2N TELEKOMUNIKACE a.s., www.2n.cz
®
1.
2.
Volume Setting
Use the trimmer on the electronics board to adjust the volume (refer to the Description
of Terminals, Connectors and Jumpers above).
Mounting Completion
Having connected all the wires, check the bushings if employed for tightness.
Install the front panel carefully. Make sure that the wires inside the device
are placed so that there is space for the front panel. Tighten the four screws
again with the enclosed Torx 20 spanner, for example, to fit the panel into
position on the metal chassis.
Caution
The audio unit is powered via a 2-wire bus. Unplugging these wires results
in the audio unit switch-off.
Caution
Use the trimmer to set the best acoustic properties while eliminating
feedback.
Caution
A wrong mounting procedure may deteriorate the Fireman's water
resistance and damage the electronics due to water leakage.
is assembled with stainless steel screws. Using 2N Lift8 Fireman
®
different, lower-quality screws may lead to screw and surface corrosion!